Tutorial written by : cityson
Last edited: August 10, 2003

Disclaimer
I will not hold responsibility for anything that might happen to your Xbox, opening it will void the manufacturer’s warranty. All actions you followed in this tutorial are done so at your own risk buddy.

Install Diagram:

Tool needed:
-Torx 10 Screwdriver. (To open the Xbox case and unscrew a screw on the mobo.)

Instructions:
-Unplug power cord.
-Take out HDD + DVD drive.
-Unclip the stock fan using a screwdriver...(You know where the clips are...)
-Take a look at the fan’s plug. Use a needle to pinch out the “black” wire.
-Ground the “black” wire under a screw on the mobo. as shown.

-Leave the “red” wire the way it is though. (You see the “red” wire’s always plugged in.)

P.S. MAKE SURE THE “BLACK” WIRE’S TIP IS TOUCHING THE “SILVER” PART UNDER THE SCREW! FAIL TO DO SO WILL MAKE YOUR XBOX “RESTART” FREQUENTLY DURING THE NEXT BOOTUP!

That’s all, thank you for reading this. Hope it helps.