Tutorial written by : Rene E.
Last edited: April 2, 2004

List of needs for this mod:
1.Chameleon solderless adaptor
2.Any xecutor chip lpc
3.soldering iron any will do "I used a 11 dollar cheapo from lowes"
4.Unmodded xbox
5.No brainer

Ok first you need to break off the pin on the solderless adapter thats connected to the do wire.
Then find the ground and d0 wire in kit you bought then solder the grey Do to the do wire on the solderless adapter
Ok your almost done now put the ground wire under the adaptor then tighten it down make sure you have cleaned the lpc points
and everything else like ground points and its an easy alignment if you know where the D0 point.
Ok now connect the usb adapter that came with executor chip you need this if you have 2.3 lite or pro I guess so use it its simple connection
Now take off the front face plate make sure the power is not connected then run your wire for the external switch. After the wire is ran put the face plate back on then you then connect the other ground on the front left hand screw then attach the wires to chip and put the chip on the solderless adapter then put everything back together boot up and yopu should have

Tutorial written by : Rene E.