Tutorial written by : smokeingit (posted on our forums here)

Okay i heard some BS that you cant fix the TSOP if you delete or screw up the TSOP... now thats a lie and i am gonna prove it...
with smokey's challenge...

What i do when fixing TSOP's that people screw up and i fix...

1. solder both top and bottom jumpers to enable writing on tsop ....

Spot 1 for v1.0/v1.1 xbox (MCPX RD)

Spot 1 for v1.2 xbox with Winbond

Spot 2 for v1.0/v1.1 xbox (MCPX WR)

Spot2 for v1.2 xbox with Winbond

WARNING! If you have a v1.0/v1.1 with a Sharp TSOP (brand of the chip) , you have to do an additional link on the back of your xbox motherboard (link TSOP.p11 to +5V).

2. now may sure you have EvoX_MatriX_TSOP_flash.zip already flashed to the matrix.... dont do it after... because it just wastes time and can cause user error...
no one wants that.

3. connect a thin single thread wire to T1, dont solder the bitch. use small amounts of hot gule or tape.

4. now install chip into xbox and put it on mode 4 with out the ground connected to T1.
the xbox (eject button)will blink orange and green.... YOU WANT THIS!!! this will let you know that the chip is installed right...
seeing nothing else is no good. The eject button must blink orange and green.
once it is blinking green and orange, dont touch move the matrix around. it is already set.

5. once you did number 4 turn off the system and put the matrix on mode 3 and put the T1 to the screw (ground) and boot it up.
once booted remove the T1 cable from the screw...

6. once booted up use your fav boot disk. Slayers 1.5 or 2.0 or use evox CD to flash your TSOP!

Thats it and it works like a charm every time... no matter what anyone says.